Learn to Clean Your Furnace Tubes Efficiently

There are several things which can contaminate a furnace. Most of them are the rust that accumulated on the Furnace Tubes. Keeping a clean and dust free furnace keeps it good and helps in the long run. Furnaces should be cleaned on a regular basis and proper maintenance should be carried out. Rusted parts of the furnace cost a lot and therefore have to be maintained rather than replaced. Natural gas and propane fueled furnaces are easy to clean by ourselves. This job is rather easy and can be done by regular people. But in case of oil powered furnaces, cleaning of the Furnace Furnace Cleaning Red Deer Tubes needs professional care. We here have listed all the steps on how to clean and maintain you furnace so that is gives you the best performance.

Steps to clean you Furnace Tubes:

First of all, we need to check if the furnace is off. We should prevent all the mishaps that can happen. The furnace would have a door for the combustion chamber. We need to remove this door. Some furnaces have a cover over them. We should remote that too prior to cleaning it. Now, we would shut off the gas valve.

Now comes the turn of the main job of cleaning the Furnace Tubes. We can always use a vacuum cleaner for the job. Vacuum the entire area of the furnace with the cleaner using the big hose for dusting. We should always check the base and the burners. That’s where most of the combustion takes place. We should use a smaller hose of the vacuum cleaner to clean the place carefully. This helps in reaching the smallest creaks of the burners so that they get cleaned properly. Use the longer extension of the vacuum cleaner to reach the backside of the furnace. This will help in cleaning the whole area.

Lift the bottom door to check for any deposits there. We cannot be sure as to how much debris may be collected in there. Use a torch light to check all the darkest parts of the Furnace Tubes also. Cleaner Furnace Tubes ensure proper flow of the fuel. Sometimes there can be slight cracklings on the sides of the burners too. These should be inspected closely.

You can check the furnace cleanliness by lighting up the furnace. If the flame in yellow and blue, it means it’s clean, but if instead it indicates a yellow and bending flame, cleaning maybe required more. After making sure the furnace is clean, close all the doors and panels inside the furnace and finally put the combustion chamber door back in is place.

There are certain precautions to be considered in cleaning the Furnace Tubes. One should replace the filters regularly in 1 to 3 months and check whether there is any leak in the furnace. This can be seen by deposited soot in the furnace which may indicate cracks. Always have a manual by the side in case if anything wrong happens. But most importantly, never hesitate to call a professional.

Leave a Reply

Your email address will not be published. Required fields are marked *